Ducted vs. Recirculating Mode: What’s The Difference?

Stainless steel chimney hood above an induction hob

Open a window after a fry-up and you are already running a ducted extractor, just a very inefficient one. Every cooker hood ends up doing one of two things with the air it pulls in: sending it outside, or cleaning it and handing it back to the room. Most hoods can be set up either way. Which one you choose shapes how your kitchen feels at the end of the evening, and what you spend on filters for years afterwards.

What a cooker hood actually does

A cooker hood, also called a chimney hood, range hood or extractor, is a fan in a box above the hob. The motor pulls rising air up through a metal grease filter, which catches the droplets of fat that would otherwise settle on your cabinets and ceiling. What happens to the air after that depends on how the hood is installed. In ducted mode it carries on up a pipe and out of the building. In recirculating mode it passes through a second, charcoal filter and comes back out through vents in the hood itself. Same appliance, two quite different results.

Ducted and recirculating: where the air goes

  • Ducted mode. The hood connects to a duct that runs to an outside wall or the roof. Smoke, grease, smell and steam all leave the house. As that air goes out, fresher air is drawn in through doors, windows and gaps to replace it, so the kitchen genuinely changes its air while you cook.
  • Recirculating mode. There is no duct. The hood traps grease in its metal filter and passes the air through activated charcoal, which soaks up odour molecules, then blows it back into the room. It is the practical answer where no outside route exists, but it cannot remove steam or heat, and the charcoal only works until it is full.

Why we recommend ducting when you can

  • It removes what a filter cannot. Charcoal deals with smell. It does nothing about water vapour or the heat coming off the hob. The City of London’s guidance on condensation puts a typical family’s indoor moisture at up to 20 litres a day, with cooking one of the biggest sources. Ducting sends the kitchen’s share outside instead of onto the windows and into the grout.
  • It is kinder to your lungs. Gas burners and hot pans release fine particles and, in the case of gas, nitrogen dioxide. Researchers at Lawrence Berkeley National Laboratory found that recirculating hoods with good filters can cut particles substantially, but only venting outdoors removes everything the hood captures. If you cook on gas, that difference matters most.
  • It costs less to run. Newmatic chimney hoods come with a metal grease filter as standard. In recirculating mode you also need a charcoal filter, bought separately and replaced on the schedule in the manual. A German study funded by the federal building research institute found the best charcoal filters removed just under 95 per cent of odours when new, while weaker ones managed only around 80 per cent, and both lose ground as they fill. Those replacements add up over the life of the hood.

Getting your hood set up

If you are building or renovating, plan the duct early, before the cabinets and ceiling go in. Keep the route short and straight and the duct at the size your hood specifies. One more thing to raise with your installer: a powerful ducted hood pulls a lot of air out of a sealed home, and building codes in the United States, for example, require a dedicated supply of replacement air above a certain fan size. In most homes, simply leaving a window slightly open while the hood runs helps it draw properly. Newmatic offers delivery and installation of chimney hoods in selected areas, and can core a hole through the wall for the duct, for a small fee, where one is needed. See our Delivery & Installation page, or ask at a showroom.

Bring your kitchen plans to life

Explore the Newmatic range, compare the details that matter to you, and visit a showroom for help planning your kitchen.